#4200 Aqua-Sheen
Acrylic Satin Enamel
Aqua-Sheen will give maximum performance when used on properly prepared interior and exterior surfaces. Ideal for use on trim, sash, wood siding and primed metals. Aqua-Sheen exhibits outstanding gloss retention, is high hiding and low odor. This product is also an ideal choice for commercial or rental property due to the excellent scrub and ability to be washed.
Colors:
White, Stock Colors and Light Tints. Factory Custom colors with a 100 gallon minimum.
Packaging:
Gallons, 5 Gallon Pails.
Finish:
Satin (low-sheen).
Substrates:
Properly primed wood, masonry, and metal.
Drying Time:
To Touch - 1 to 2 Hours.
To Recoat - 4 to 6 Hours.
Under normal weather conditions @70° F, 50% relative humidity.
Coverage:
275-375 sq ft per gallon depending on surface texture and porosity of surface.
Surface Preperation:
All surfaces must be clean and dry and free of dust, loose paint, and surface contaminants that may impair adhesion.
V.O.C.:
Does not exceed 50 grams per liter.
Application:
Airless or conventional spray, brush or roll.
Primers:
Recommended primers are listed below.
Drywall - #63 Dynacoat Enamel Undercoat, #PV101 PVA Sealer.
Brick - #7509 "F" Stop, #95 Busan Acrylic Primer, #330 Draw Tite.
Wood (new) - #95 Busan Acrylic Primer, #63 Dynacoat Enamel Undercoat (interior only).
Wood (painted) - #300 Bus-Stop 100% Acrylic Primer, #97 Selz².
Metal (ferrous) - #301 Rust Stop Red Oxide Primer, #302 Rust Stop White Primer.
Metal (non-ferrous) - #95 Busan Primer, #300 Bus-Stop 100% Acrylic Primer, #302 Rust Stop White Primer, #97 Selz².
Thinning:
Small amount of clean water if required.
Clean Up:
Soap and warm water clean up.